Using the Ten-Tec 302R Remote Encoder with the Omni 6
If you're willing to wire an adapter cable, you can use the Ten-Tec 302R Remote Encoder with the Omni 6. Here is the wiring info, that includes connection for the CAT port:
Signal | 302R DIN8 | Omni6 DB25 | PC COM port DB9 |
---|---|---|---|
*Encoder A | pin 1 | pin 8 | |
*Encoder B | pin 6 | pin 6 | |
Ground | pin 2 | pin 1, 7 or 14 | pin 7 |
+5V | pin 8 | pin 16 | |
TX Data | pin 2 | pin 3 | |
RX Data | pin 3 | pin 2 |
*In addition, 10K ohm pull-up resistors need to be added between each Encoder line and +5V
If the encoder tunes backwards, swap wires on DIN8-1 and DIN8-6
page revision: 6, last edited: 20 Nov 2015 19:18